Duravent DuraLiner Installation Uživatelský manuál

High-Temperature, Factory Insulated Double-Wall Masonry Relining system5" Round6", 8" Round and OvalDuraLiner®Installation Instructions

NOTE: MINIMUM CLEARANCE FOR SINGLE WALL STOVEPIPE IS 18 INCHES. FOR DVL PIPE, THE MINIMUM IS 8 INCHES.EXTEND-A-CAP ASSEMBLYMINIMUM CLEARANCE: (NOTE BE

11Check the appliance manufacturer’s installation instructions to ensure proper positioning with relation to combustibles. Complete the installation w

12Do not construct chases or other enclosures around DuraLiner pipe sections which extend above the masonry.LINER1/2" OF PROFOILALUMINUM TAPEPROM

13Figure 21TRANSITION ANCHOR PLATE ASSEMBLYCHIMNEYHANGERTRANSITION ANCHOR PLATESLIP CONNECTORDURALINERHOLD DOWN BRACKETSTRANSITION ANCHOR PLATE Ensure

INSTALLATION NOTES:14

INSTALLATION NOTES:15

M&G DURAVENT LIMITED LIFETIME WARRANTYM&G DuraVent, Inc. (“DuraVent”) provides this limited lifetime warranty for all of its products with the

A MAJOR CAUSE OF VENT RELATED FIRES IS FAILURE TO MAINTAIN REQUIRED CLEARANCES (AIR SPACES) TO COMBUSTIBLE MATERIALS. IT IS OF THE UTMOST IMPORTANCE

3CONTENTSAPPLICATION AND LISTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5GENERAL INSTALLATION INSTRUCTIONS . . . .

4TYPE A B6" ROUND 7" 7"8" ROUND 9" 9"6" OVAL 8" 5 1/2"8" OVAL 11 5 1/2" - 6"IMPORTANT MEAS

5APPLICATION AND LISTINGDuraLiner is a double-wall, insulated all-fuel reliner for masonry chimneys, used for natural draft venting of gas, liquid and

6From the appliance up through the damper area to the rst ue tile, it is not mandatory to insulate ex pipe. Above the rst ue tile, ex pipe must

7pipe with a 5/32” (4 mm) diameter twist drill bit. Next, install the pop rivets. Drilling is not needed to connect sections of rigid pipe. Connect

8clearance to the ceiling for single wall pipe is 18", and for DuraVent Close Clearance Connector (DVL) Pipe, 8" (Fig.12).can be used to con

9STEP THREE: Using DuraVent's Masonry Thimble with Slip Connector, connect slip connector to Tee Branch with the pre-formed buttons. Slide Maso